Automatic address assignment, Automatic address assignment -16 – Xerox 8560 User Manual
Page 33
IPv6
Phaser® 8560/8860 Printer
2-16
Automatic Address Assignment
Addresses are assigned automatically when a router is found that offers one or more prefixes.
Automatically assigned addresses are routeable. Each router-supplied prefix is combined with
the Interface ID to create an address. The use of router-supplied prefixes is enabled by default.
To enable/disable automatic address assignment, use one of the following options:
■
The printer’s control panel
■
CentreWare IS
Enabling/Disabling Automatic Address Assignment with the Control Panel
To set the Interface ID on the control panel:
1.
Select
Printer Setup
, and then press the OK button.
2.
Select
Connection Setup
, and then press the OK button.
3.
Select
Network Setup
, and then press the OK button.
4.
Select
TCP/IPv6 Setup
, and then press the OK button.
5.
Select
Auto Assign
, and then press the OK button to turn Auto Assign
On
or
Off
.
Enabling/Disabling Automatic Address Assignment with CentreWare IS
To set the Interface ID with CentreWare IS:
1.
Launch your web browser.
2.
Enter your printer’s IP address in the browser’s Address field.
3.
Click Properties.
4.
Select the Protocols folder on the left navigation panel, and then click TCP/IP.
5.
Click the TCP/IP (v6) button.
6.
Select/deselect Use router supplied prefixes.
7.
Click the Save Changes button at the bottom of the page.