Xerox 701P21110 - Manual (Page 34)

Managing and printing jobs from the Tape Client
2-10 Tape Client Job Submission Guide
Figure 2-7. Job Descriptor Library window
4. On the resources list, click the name of the JDL, JDE, or form
that you want to use for the job. Your selection appears in the
read-only Selection field.
5. Click OK. The library window closes, and the name of the
resource that you selected appears in the read-only Initial...
field on the Tape Client window.
NOTE: If you selected a new JDL, a window displays the
following message when you click OK:
You may have to select a new JDE entry.
When you click OK to close the message window, the Job
Descriptor Entry library window opens. Select an initial JDE
from this window, then click OK to close it.
6. Repeat steps 3 through 5 for any other initial resources that
you want to specify.