Winbook X Series X2 - Manual (Page 119)

User Password Is: This item displays the current status of the User
Password: Set or Clear.
Set Supervisor Password: This item allows you to set or clear the super-
visor password. If the supervisor password has been enabled, you will need
to log in as the supervisor to clear or change the password. Press [Enter]
to set or clear the password.
• To set the password, enter a password in the space provided. Press
[Enter]. Type the same password again (to provide verification of the
password) in the second line and press [Enter]. The password will
now be set.
7.12
Series
User’s Manual
If you choose to enable
the password, be sure to
write down the password
and store it in a safe place. If
you ever forget this password,
you will be unable to use the
system or change the BIOS set-
tings. You will need to return
the unit to WinBook to restore
full functioning to the system
in this event.
Figure 7.7: The Security Menu
PhoenixBIOS Setup Utility
Item Specific Help
F1 Help
ESC Exit
Select Item
Select Menu F5/F6 Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
Main Advanced Security Boot Exit
Supervisor Password Is: Clear
User Password Is: Clear
Set Supervisor Password [Enter]
Set User Password [Enter]
Diskette access: [Supervisor]
Fixed disk boot sector: [Normal]
Virus check reminder: [Disabled]
System backup reminder: [Disabled]
Password on boot: [Disabled]
Supervisor Password con-
trols access to the setup
utility.
➔
➔
➔ ➔
X Manual WinME w/photos 2/01/01 3/19/01 4:24 PM Page 124