Winbook X Series X2 - Manual (Page 116)

I/O Device Configuration Submenu (Figure 7.6)
Serial Port: This item allows you to enable or disable the serial port.
When enabled, this port should be set to “Auto” (which will automatically
set the address on system start-up). Be aware of conflicts that might arise
if you add devices that require a COM port (such as a modem). If conflicts
arise, you can disable the serial port (and enable it again when you need
to use it) by setting it to “Disabled.” If the OS has control of the Serial
port, you will see “OS Controlled” displayed for this item.
Chapter 7: Configuring & Maintaining Your System
7.9
Figure 7.5: The Advanced Chipset Control Submenu
PhoenixBIOS Setup Utility
Item Specific Help
F1 Help
ESC Exit
Select Item
Select Menu F5/F6 Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
Advanced Chipset Control Submenu
Advanced Chipset Control
Embedded Share Memory [8MB]
USB BIOS Legacy Support: [Disabled]
Embedded AGP VGA Share
Memory Size.
➔
➔
➔ ➔
Advanced
X Manual WinME w/photos 2/01/01 3/19/01 4:24 PM Page 121