Winbook X Series X2 - Manual (Page 117)

Parallel Port: This item allows you to enable or disable the parallel port.
When enabled, this port should be set to “Auto” (which will automatically
set the address on system start-up). If you choose the Auto option, you will
have the option of setting the Parallel Port mode. If conflicts arise, you can
disable the parallel port (and enable it again when you need to use it) by
setting it to “Disabled.” If the OS has control of the parallel port, you will
see “OS Controlled” displayed for this item.
7.10
Series
User’s Manual
Figure 7.6: The I/O Device Configuration Submenu
PhoenixBIOS Setup Utility
Item Specific Help
F1 Help
ESC Exit
Select Item
Select Menu F5/F6 Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
I/O Device Configuration Submenu
I/O Device Configuration
Serial port A: [Auto]
Parallel port: [Auto]
Mode: [ECP]
PS/2 Mouse: [Auto Detect]
Configure serial port A
Using options:
[Disabled]
No configuration
[Auto]
BIOS or OS chooses
configuration
[OS Controlled]
Displayed when
controlled by OS
➔
➔
➔ ➔
Advanced
X Manual WinME w/photos 2/01/01 3/19/01 4:24 PM Page 122