Wolf Ventilation Hood - Manual (Page 15)

Cooktop Chimney Hood Installation 15
wolfappliance.com/specs
Island Hood Installation
WIRING CONNECTIONS
Electrical connection at the hood:
1) Remove the cover from the rear electrical box. Remove
the electrical box knockout that faces the hood's
discharge collar.
2) Insert 6" (152) Romex ® wire through the knockout
opening. Secure the Romex ® wire to the electrical box
with an appropriate connector. Use wire connectors or
wire nuts approved by UL or C/UL.
3) Make electrical connections at the hood. Connect
black to black, white to white and green/yellow to
green or bare wire.
4) Place all wiring connections inside the electrical box
and reinstall the cover. Make sure all wires are secure
and that no wires are pinched between the cover and
electrical box.
Refer to page 13–15 for internal blower installation and
remote blower wiring.
CONNECT DUCTWORK
Use 8" (203) round metal duct to connect the duct collar
on the hood to the ductwork above. Use duct sealing tape
to make all joints secure and air tight.
Slide the lower telescopic chimney flue section downward
until it fits properly around the hood shell.
Internal Blower
INTERNAL BLOWER INSTALLATION
IMPORTANT NOTE: Refer to installation instructions
provided with the internal blower assembly for additional
mounting and wiring instructions.
1) Remove the hood filters.
2) Lift the blower into position inside the hood.
3) Use four hex nuts provided with the blower to fasten
the unit to four threaded studs.
4) Plug the blowers’ single power cord (double for 900
CFM) into the receptacle(s) inside the hood. Use the
clip on the hood to keep excess power cord away from
moving parts.
5) Reinstall the hood filters.
IMPORTANT NOTE: Before turning the power on to the
ventilation hood, make sure the blower is off.