Wacom DTZ-2100D - Manual (Page 15)

Unpacking your Cintiq
Page 13
REMOVING CINTIQ FROM THE DISPLAY STAND
To remove Cintiq from the display stand:
• If the rotation lock screws are attached, remove them from the back of Cintiq.
• Position the pen display to landscape orientation before removing it from the display stand.
The stand will not release unless Cintiq is in landscape orientation.
• Next, raise the stand incline to the highest position. See Adjusting the display incline on page 11
for instructions.
• Firmly grasp the pen display on both the left and right sides of the body, and lift the unit out of the
display stand.
Important: When removing Cintiq from the display stand, always lift Cintiq in a direction
parallel to the front of the stand. You may also need to rotate Cintiq slightly so the stand will
release.
Note: When packing Cintiq for transport, first adjust the stand to its lowest position and place the foam packing
blocks under the incline adjustment levers before removing Cintiq from the stand. The foam blocks will keep
the stand from snapping shut while in its packaging. Always pack Cintiq and its stand in their original
containers and protective cushions. Never pack Cintiq while it is mounted on the stand; this may damage the
unit or stand during transportation.
Cintiq21UX_Manual.fm Page 13 Monday, November 5, 2007 10:27 AM