Wayne-Dalton 8850 - Manual (Page 9)

9
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
iNST
alla
Tio
N
3
attaching bracket mount Track &
bottom Section
None
imPoRTaNT: ThE TOPS Of ThE VERTICAL
TRACKS MUST BE LEVEL fROM SIDE
TO SIDE. If ThE BOTTOM SECTION WAS
ShIMMED TO LEVEL IT, ThE VERTICAL
TRACK ON ThE ShIMMED SIDE MUST BE
RAISED ThE hEIGhT Of ThE ShIM.
Position the left hand vertical track
assembly over the rollers of the bottom
section. Make sure the counterbalance
cable is located between the rollers and
the door jamb. Drill 3/16” pilot holes into
the door jamb for the lag screws.
Loosely fasten vertical track assembly
to the jamb using 5/16” x 1-5/8” lag
screws. Tighten the bottom lag screw to
jamb, to maintain 3/8” to 5/8” spacing as
shown between the bottom section and
vertical track. The other lag screws will be
tightened in step, Top Section.
Repeat for other side.
Stack the bottom section into position by
hooking the left hand roller into the left
hand vertical track, as shown in fIG. 1 .
NoTe: Adjust the spacing of the vertical
tracks from 3/8” - 5/8” spacing at the
bottom section and 1-11/16” to 1-3/4”
spacing at the top section.
NoTe: hang the counterbalance cables
over the top of the flagangles as shown.
Fig 1
STACK ThE SECTION
INTO POSITION, BY
hOOKING ThE LEfT
hAND ROLLER INTO
ThE VERTICAL TRACK
AND REPEATING fOR
ThE RIGhT hAND SIDE.
fIG 1
WOOD jAMB
COUNTERBALANCE
CABLE