Wayne-Dalton 8850 - Manual (Page 14)

14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
12
11
With tracks installed you can adjust
the top brackets. Vertically align the
top section of the door with the lower
sections. Once aligned, position the top
roller, out against the horizontal track.
Maintaining the slide’s position, tighten
the (1) 5/16”- 18 hex nut to secure the
top bracket slide to the top bracket base.
Repeat for other side.
adjusting Top brackets
7/16” Wrench
hORIzONTAL
TRACK
TOP BRACKET
SLIDE
CORRECT
INCORRECT
TOP ROLLER
TOP
SECTION
TOP
SECTION
TOP
SECTION
attaching horizontal Track to adjustable
Flagangle
To install horizontal track, place the curved end over the
top roller. Align the bottom of the horizontal track with
the vertical track. hand tighten the horizontal track to
the flagangle with (2) 1/4”- 20 x 9/16” track bolts and
(2) 1/4”- 20 flange hex nuts.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using
(1) 3/8”- 16 x 3/4” truss bolt and (1) 3/8”- 16 hex
nut. Repeat for other side. Remove the nail that was
temporarily holding the top section in place, installed in
Step 10.
imPoRTaNT: fAILURE TO REMOVE NAIL BEfORE
ATTEMPTING TO RAISE DOOR COULD CAUSE
PERMANENT DAMAGE TO TOP SECTION.
DO NOT RAISE DOOR UNTIL hORIzONTAL
TRACKS ARE SE CURED AT REAR, AS OUTLINED
IN STEP 20, OR DOOR COULD fALL fROM
OVERhEAD POSI TION CAUSING SEVERE OR
fATAL INjURY.
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
hammer
waRNiNg
(1) 3/8”- 16 X 3/4”
TRUSS BOLT
(1) 3/8”- 16
hEX NUT
hORIzONTAL
TRACK
hORIzONTAL ANGLE
fLAGANGLE
(2) 1/4”- 20 fLANGE
hEX NUTS
VERTICAL TRACK
hORIzONTAL
TRACK
(2) 1/4”- 20 X 9/16”
TRACK BOLTS