Wayne-Dalton 8850 - Manual (Page 4)

4
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Package contents continued...
(2) 1/4”- 20 hEX
NUTS
1/4”- 20 fLANGE hEX
NUTS (AS REqUIRED)
3/8”- 16 hEX NUTS
(AS REqUIRED)
1/4”- 20 X 7/8” SELf DRILLING
SCREWS (AS REqUIRED)
3/8”- 16 X 1-1/2” hEX hEAD BOLTS
(AS REqUIRED)
The ToP SecTioN is always the 4th
section on four section door and the 5th
section on five section door.
The iNTeRmeDiaTe i SecTioN having
warning labels on either the right or left
hand side of endstile on the section.
This section is always the 3rd section
from the bottom of the door.
The lock SecTioN can be identified
by having no warning labels and a
ribbed fin on the top part of the section.
This section is always the 2nd section
from the bottom of the door.
The boTTom SecTioN can be
identified by the factory attached
bottom astragal, or by the bottom
bracket warning labels on each end
stile. This section is always the 1st
section on four and five section doors.
Door Section identification
TOP SECTION
LOCK SECTION
BOTTOM SECTION
BOTTOM BRACKET
WARNING LABELS
ASTRAGAL
WARNING LABEL
INTERMEDIATE I SECTION
5/16” X 1 5/8” TAMPER RESISTANT
LAG SCREW (AS REqUIRED)
(2) 3/8” - 16 X 3/4”
TRUSS hEAD BOLTS
(2) CLEVIS
PINS
(2) COTTER
PINS
(2) 5/16”
WAShERS
1/4”- 20 X 9/16” TRACK
BOLTS (AS REqUIRED)
(2) 5/16” - 18 X 3/4”
CARRIAGE BOLTS
(AS REqUIRED)
(2) 3/16” ROLLER
SPACERS
5/16” X 1 5/8” hEX hEAD LAG
SCREWS (AS REqUIRED)
5/16”- 18 hEX NUTS
(AS REqUIRED)
1/4”- 20 X 5/8”
CARRIAGE BOLTS
(AS REqUIRED)
5/16” X 2” TAMPER RESISTANT LAG SCREWS
(AS REqUIRED)
5/16” X 2” hEX hEAD LAG SCREWS
(AS REqUIRED)
5/16” X 1” SELf DRILLING
SCREWS (AS REqUIRED)
1/4- 20 X 5/8” SELf
DRILLING SCREWS