Wayne-Dalton 8850 - Manual (Page 22)

22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
�
�
Side lock
(4) 1/4”- 20 X 7/8” SELf
DRILLING SCREWS
1/8”
Power Drill
7/16” Socket
Driver
Tape Measure
Pull Rope NO. 6 SCREW EYE
PULL ROPE
BOTTOM BRACKET
PULL ROPE
Install the side lock on the second section
of the door. Secure the lock to the section
with (4) 1/4”- 20 x 7/8” self drilling
screws. Square the lock assembly with
the door section and align with the square
hole in the vertical track. The side lock
should be spaced in approximately 1/8”
from the section edge.
imPoRTaNT: SIDE LOCKS MUST BE
REMOVED OR MADE INOPERATIVE IN ThE
UNLOCKED POSITION If AN OPERATOR IS
INSTALLED ON ThE DOOR.
NoTe: After completing this step, continue
with step 9 on page 13.
1/8”
DO NOT INSTALL PULL ROPES
ON DOORS WITh ELECTRIC
OPERATORS. ChILDREN MAY
BECOME ENTANGLED IN ThE
ROPE CAUSING SEVERE OR fATAL
INjURY.
Measure and mark the jamb
approximately 48” to 50” (1220 to 1270
mm) from floor on the right or left side of
door. Drill 1/8” pilot hole for No. 6 screw
eye. Install the No. 6 screw eye. Tie the
pull rope to the No. 6 screw eye and to
the bottom bracket as shown.
waRNiNg
Power Drill
1/8” Drill Bit