Wayne-Dalton 8850 - Manual (Page 24)

24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
�
OUTSIDE TRIM RING
(3) #10 X 1-1/2”
COUNTER SUNK BOLT
EXhAUST PORT
GASKET
(3) #10 hEX
NUTS
GASKET
ALUMINUM PANEL
DOUBLE WIDE
BOTTOM RAIL
Exhaust port is installed on the back side of
the bottom section into the aluminum panel
or a double wide bottom rail.
NoTe: Gaskets need to be installed against
both sides of the door section.
Install the exhaust port using (3) #10 x 1-1/2”
counter sunk bolts and nuts, as shown.
NoTe: After completing this step, continue
with step 9 on page 13.
exhaust Port installation