Wayne-Dalton 8850 User Manual
Page 8
8
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
1
attaching counterbalance cables
to bottom brackets
BOTTOM SECTION
ASTRAGAL
None
imPoRTaNT: RIGhT AND LEfT hAND IS
ALWAYS DETERMINED fROM INSIDE ThE
GARAGE LOOKING OUT.
NoTe: for door section identification see
page 4.
Uncoil the counterbalance cables and slip
the loop at the ends of the cables over
each clevis pin in the bottom bracket.
Insert a roller into bottom bracket of the
bottom section.
Insert cotter key and separate end to hold
the clevis pin in place.
Repeat for other side.
NoTe: Verify astragal (bottom seal) is
aligned with door section. If there is more
than 1/2” excess astragal on either side,
trim astragal even with door section.
Standard bottom brackets: (a) Locate the
bottom section and the left and right hand bottom
brackets. Secure the counterbalance cables to the
brackets using clevis pin, washer and cotter key
as shown in the previous step. Secure bottom
brackets to bottom section using (5) 1/4” -20 X
7/8” self drilling screws as shown. Insert a roller
into the bottom brackets as shown.
2”/3” bottom brackets with Roller carriers:
(b) Secure the counterbalance cables in the same
manner as described above in the previous step.
Attach the bracket to the section with (5) 1/4”
-20 X 7/8” self drilling screws. Attach the roller
carrier to the bottom bracket with (4) 1/4” -20 X
7/8” self drilling screws. Insert a roller and 3/16”
roller spacer into the roller carrier; the inner holes
of the roller carrier are for 2” track; the outer holes
of the roller carrier are for 3” track.
bottom bracket
Power Drill
7/16” Socket
Driver
2
COTTER KEY
CLEVIS
PIN
BOTTOM
BRACKET
COUNTER-
BALANCE
CABLE
WAShER
BOTTOM
BRACKET
ASSEMBLY
(5) 1/4” -20
X 7/8” SELf
DRILLING
SCREWS
BOTTOM
SECTION
ROLLER CARRIER
(4) 1/4” -20 X 7/8”
SELf DRILLING
SCREWS
ROLLER
3/16”
ROLLER
SPACER
INNER hOLES fOR
2” TRACK
OUTER
hOLES fOR
3” TRACK
WAShER
COTTER KEY
COUNTER-
BALANCE
CABLE
BOTTOM
BRACKET
CLEVIS
PIN
A
BOTTOM
BRACKET
BOTTOM
SECTION
WARNING
LABEL
ASTRAGAL
B
(5) 1/4” -20
X 7/8” SELf
DRILLING
SCREWS
ASTRAGAL