Wayne-Dalton 8850 - Manual (Page 11)

11
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
iNST
alla
Tio
N
11
6
Stacking Sections
Power Drill
7/16” Socket
Driver
NoTe: for door section identification see
page 4.
Locate the Lock Section (the second section)
and insert a roller into the left end hinge.
Stack this section into the opening by hooking
the roller into the left hand vertical track and
lowering the section onto the bottom section,
as shown. Insert a roller into the proper,
uninstalled right hand end hinge, and place
the roller into the right hand vertical track.
Lower the roller and hinge into the proper
position over the section, and attach to the
section in the same manner the left hand
end hinge was attached, as described on
step 5. Verify section alignment, and flip
up the upper hinge leaf(s) from the bottom
section and secure to the lock section using
1/4”-20 x 7/8” self-drilling screws. Continue
to stack the remaining sections in the proper
sequence, except for the top section.
LOCK SECTION
hOOK LEfT hAND
ROLLER INTO TRACK
SLIDE RIGhT ENDhINGE AND
ROLLER DOWN VERTICAL TRACK
AND OVER LOCK SECTION
screws, as shown .
To install center hinges on doors with
integral fins, seat the bottom half of the
half hinge(s) onto the integral fin above the
center stile(s) and over the pre-drilled holes
on each section, and secure to the fin with
(2) 1/4”-20 x 5/8”carriage bolts and (2) 1/4”
- 20 flange hex nuts, as shown. Repeat for all
remaining sections, except top section.
hINGE
CENTER STILE
#1
hALf
hINGE
CENTER
STILES
CENTER hINGE PLACEMENT AND BEING ASSEMBLED
CENTER hINGE BEING ASSEMBLED
(2)1/4”- 20 X 5/8”
CARRIAGE BOLTS
(AS REqUIRED)
(2) 1/4” - 20
fLANGE hEX
NUT
#1 hALf hINGES
PUNChED
hOLES
(4) 1/4” -20 X 7/8”
SELf DRILLING
SCREWS
#1
hINGE
(2) 1/4” - 20 X
7/8” SELf DRILLING
SCREWS
CENTER
STILE
hINGE
CENTER hINGE ASSEMBLED
ENDhINGE ChART
Section
2 inch track 3 inch track
Bottom #1 hinge #3 hinge
Second #2 hinge #4 hinge
Third #3 hinge #5 hinge
fourth #4 hinge #6 hinge
fifth #5 hinge #7 hinge
hinges are stamped with their identification,
as shown above on the #1 half hinge.
hinges continued...