Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 27)

27
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INST
All
ATION
FaIluRE TO PlaCE VICE ClaMPs
ONTO VERTICal TRaCk CaN
allOW DOOR TO RaIsE aND
CausE sEVERE OR FaTal
INjuRy.
Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding counterbalance springs.
IMPORTANT: DO NOT usE IMPaCT GuN
TO WIND sPRING(s).
Securing Door
for Spring winding
TRaCk
VICE ClaMPs
aTTaChED TO
INNER RaIl
OF TRaCk
Vice Clamp
COuNTERBalaNCE
CaBlE
sET sCREW
CaBlE
DRuM
locking Pliers
Flat Tip
screwdriver
CaM PEak
sTRaIGhT uP
Rotate the cable drum until the set
screw faces directly away from the
header. TorqueMaster
® spring tube cam
peak should be pointing straight up.
Beginning with the right side, loosen
the set screw approximately 2 turns, to
adjust cable. using locking pliers, pull
on the end of the cable to remove all
cable slack.
Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.
Cable Adjustments
wARNINg
27
28
PlaCE VICE
ClaMPs aBOVE
3RD ROllER