Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 11)

11
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
Installation
IMPORTANT: REaD INsTRuCTIONs TITlED “P4” “REMOVING ThE OlD DOOR” ON PaGE 9 aND “P5” “PREPaRING ThE OPENING” ON
PaGE 10 BEFORE aTTEMPTING DOOR INsTallaTION.
IMPORTANT: sTaINlEss sTEEl OR PT2000 COaTED laG sCREWs MusT BE usED WhEN INsTallING CENTER BEaRING BRaCkETs,
END BRaCkETs, jaMB BRaCkETs, OPERaTOR MOuNTING/suPPORT BRaCkETs aND DIsCONNECT BRaCkETs ON TREaTED luMBER
(PREsERVaTIVE-TREaTED). sTaINlEss sTEEl laG sCREWs aRE NOT NECEssaRy WhEN INsTallING PRODuCTs ON uN-TREaTED
luMBER.
NOTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and
1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.
INST
All
ATION
None
Attaching quick Install flag
Angle to vertical Track
NOTE: If you have riveted track, skip this
step.
Place the lower quick install tab of the
flagangle in the quick install feature of
the vertical track. Give the flagangle 1/4
turn to lock in place. Repeat for other
side.
quICk INsTall TaB uNlOCkED quICk INsTall TaB lOCkED
FlaGaNGlE
VERTICal
TRaCk
1
lEFT haND TRaCk aND FlaGaNGlE RIGhT haND TRaCk aND FlaGaNGlE
FlaGaNGlE
VERTICal
TRaCk