Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 24)

Tools Needed:
24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
Positioning Support bracket
23
usING a TaPE MEasuRE, MaINTaIN aN Equal MEasuREMENT “x”
(TOP OF DOOR TO BOTTOM OF TORquEMasTER® TuBE) aT BOTh
ENDs aND ThE CENTER.
TOP sECTION
“x” “x”
NOTE: see idrive ® main installation and
owners manual for idrive ® parts.
NOTE: idrive ® must be installed on a
solid mounting surface.
locate the mounting surface. Remove
(2) 1/4”-20 flange nuts from bottom of
opener.
NOTE: Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. using a
tape measure, level the bottom of the
TorqueMaster
® spring tube to the top of
the door section with the idrive ® resting
on the support bracket. Once
TorqueMaster
® spring tube is level, drill
1/8” pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4” x 1-1/2" lag
screws.
IMPORTANT: TORquEMasTER ® sPRING
TuBE MusT BE lEVEl aFTER suPPORT
BRaCkET Is FasTENED TO MOuNTING
suRFaCE.
NOTE: If wood mounting surface is
behind dry wall, use 1/4” x 2” lag
screws.
lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. loosely
fasten to mounting studs with the (2)
1/4”-20 flange nuts.
NOTE: Do not tighten 1/4”-20 flange
nuts to opener studs at this time. you
will be instructed when to tighten them
in the idrive
® main installation and
owners manual.
Remove the temporary orange label
holding the antenna wire. straighten
antenna wire and angle it 45 degrees to
the right.
NOTE: Do not coil the antenna wire.
This will reduce the radio signal range.
Power Drill
1/8” Drill Bit
7/16” socket
Driver
45 aNGlE
aNTENNa
WIRE
MOuNTING
suRFaCE
(hEaDER)
TOP OF DOOR
suPPORT
BRaCkET
1/4” x 1-1/2”
laG sCREWs
1/4” - 20
FlaNGE NuTs
MOuNTING
sTuDs
MOuNTING
sTuDs
BRaCkET
slOTs
suPPORT
BRaCkET TORquEMasTER ®
sPRING TuBE
(2) 1/4” - 20
FlaNGE NuTs
TORquEMasTER ®
sPRING TuBE
“x”