Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 12)

Tools Needed:
12
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key
slot of horizontal track. using a hammer,
tap the horizontal angle towards the
curved end of the track until the holes in
track and angle are aligned. set tracks
aside.
NOTE: For larger doors, a full length
horizontal angle may be spot welded to
the horizontal track. If the horizontal angle
is not welded, the horizontal angle will be
installed as shown.
horizontal Angle
hammer
hORIzONTal
TRaCk
hORIzONTal
aNGlE
hORIzONTal aNGlE
hORIzONTal TRaCk
hOlE
hOlE TaBs
kEy slOT
2
hORIzONTal
TRaCk
TaBs
hORIzONTal
TRaCk
hORIzONTal
aNGlE
NOTE: If you have riveted track, skip this
step.
Measure the length of the vertical tracks.
using the jamb bracket schedule,
determine the placement of the jamb
brackets for your door height and track
type. To install the jamb brackets,
align the twistlock tab on the quick
install jamb bracket with the quick
install feature in the track and turn the
bracket perpendicular to the track so the
mounting flange is toward the back (flat)
leg of the track.
Installing q.I. Jamb brackets
TOP
hOlE
BOTTOM
hOlE
MIDDlE
hOlE
3RD sET hOlEs
2ND sET hOlEs
1sT sET hOlEs
None
3
quICk INsTall FEaTuRE
lEFT sIDE shOWN RIGhT sIDE shOWN
q.I. jaMB BRaCkET
TWIsTlOCk TaB
JAMb bRACkET SChEDUlE
DOOR
hEIghT
1ST SET 2ND SET 3RD SET
JAMb bkT POSITION JAMb bkT POSITION JAMb bkT POSITION
7’0”
76” TRACk (1930 mm)
qIjB - 3 BOTTOM qIjB - 7 TOP NOT aPPlICaBlE
8’0”
88” TRACk (2235 mm)
qIjB - 3 MIDDlE qIjB - 6 TOP qIjB - 7 MIDDlE
haMMER