Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 18)

Tools Needed:
18
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INCORRECT
Attaching horizontal Track
to quick Install flagangle
To install horizontal track, place the
curved end over the top roller. align key
slot of the horizontal track with the quick
install tab of the flagangle. Push curved
portion of horizontal track down to
lock in place. level the horizontal track
assembly and bolt the horizontal angle
to the slot in the flagangle using (1)
3/8” - 16 x 3/4” truss head bolt and (1)
3/8” - 16 hex nut. Repeat for other side.
Remove the nail that was temporarily
holding the top section in place, installed
in step 12.
IMPORTANT: FaIluRE TO REMOVE NaIl
BEFORE aTTEMPTING TO RaIsE DOOR
COulD CausE PERMaNENT DaMaGE TO
TOP sECTION.
DO NOT RaIsE DOOR uNTIl hORIzONTal
TRaCks aRE sE CuRED aT REaR, as
OuTlINED IN sTEP 32, OR DOOR COulD
Fall FROM OVERhEaD POsI TION
CausING sEVERE OR FaTal INjuRy.
NOTE: If an idrive ® opener will be
installed, position horizontal tracks slightly
above level.
kEy
slOT
quICk
INsTall
TaB
hORIzONTal
TRaCk
VERTICal
TRaCk
Fla
Ga
NG
lE
13
14
wARNINg
9/16” socket
Ratchet Wrench
9/16” Wrench
level kEy slOT
quICk
INsTall
TaB
hORIzONTal
TRaCk
VERTICal
TRaCk
Fla
Ga
NG
lE
3/8” - 16 x 3/4”
TRuss hEaD BOlT
3/8” - 16 hEx NuT
hORIzONTal TRaCk
hORIzONTal aNGlE
Adjusting Top brackets
With horizontal tracks installed, you can
now adjust the top brackets.
Vertically align the top section of the
door with the lower sections. Once
aligned, position the top bracket slide,
out against the horizontal track.
Maintaining the slide’s position, tighten
the (2) 1/4” - 20 flange hex nuts to
secure the top roller slide to the top
bracket base.
hORIzONTal
TRaCk
TOP
BRaCkET
slIDE
(2) 1/4” - 20
FlaNGE hEx
NuTs
CORRECT
7/16” Wrench
TOP
sECTION
TOP
sECTION
TOP
sECTION