Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 26)

Tools Needed:
26
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
NOTE: see idrive ® main installation and
owners manual for idrive ® parts.
NOTE: Bring motor to the down position
by pulling the disconnect cable, insure
opener disconnect teeth are engaged
before installing disconnect handle.
start the #6-20 x 1/2" screw into the
disconnect handle. Thread the disconnect
cable through the top of the disconnect
handle bracket and then the disconnect
handle.
locate the disconnect handle in full
upper position of disconnect handle
bracket.
Remove all disconnect cable slack
between the opener and the top of the
disconnect handle bracket. Tighten
#6-20 x 1/2" screw into the disconnect
handle until snug, and then tighten screw
an additional 1 to 1-1/2 turns to secure
disconnect cable to the disconnect
handle. Trim off excess cable from
bottom of the disconnect handle.
CAUTION: Pull CaBlE ONly TauT
ENOuGh TO REMOVE ThE CaBlE slaCk.
PullING ThE CaBlE MORE COulD
CausE OPENER TO DIsCONNECT FROM
ThE TORquEMasTER
® sPRING TuBE.
apply emergency disconnect label next
to the mounted bracket. use mechanical
fasteners if adhesive will not adhere.
using the emergency disconnect, pull
disconnect handle downwards and
place it in the manual door operated
position (use disconnect label for
reference). Motor will be rotated 90°
from its packaged position.
If motor does not pivot 90°, see
troubleshooting section in the main
installation and owners manual of your
idrive ® opener
Attaching Disconnect handle
Phillips head
screwdriver
Wire cutters
#6-20 x 1/2”
sCREW
DIsCONNECT
haNDlE
BRaCkET
DIsCONNECT
CaBlE
haNDlE
MANUAl OPERATED POSITION
uPPER POsITION
EMERGENCy DIsCONNECT
laBEl
MOTOR OPERATED POSITION
26