Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 15)

15
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INST
All
ATION
Top brackets
(4) 1/4” - 14 x 5/8”
sElF TaPPING
sCREWs
TOP BRaCkET BasE
TOP BRaCkET slIDE
(2) 1/4” - 20
FlaNGED hEx
NuTs
(2) 1/4” - 20 x 5/8”
CaRRIaGE BOlTs
ROllER
TOP BRaCkET slIDE
Power Drill
7/16” socket
Driver
1sT sET
2ND sET
To install the l-shaped top brackets,
align the top holes in the top bracket
base with the second set of holes in the
endcap.
Fasten using (4) 1/4” - 14 x 5/8” self
tapping screws. secure the top bracket
slide to the bracket base loosely using
(2) 1/4” - 20 x 5/8” carriage bolts and
(2) 1/4” - 20 flanged hex nuts. The
bracket will be tightened and adjusted
in step 14. Insert rollers into top bracket
slide. Repeat for other side.
8
TOP sECTION
TOP sECTION
TOP sECTION
NOTE: If you have a model 5120 or 5140
series door with windows in the top
section, skip this step and complete step
10.
NOTE: Model 5120 series door over 13’
wide require a 3” u-bar (supplied).
Place the 3” u-bar over the top rib of the
top section. Fasten each end of the u-bar
to the endcap with (2) 1/4”- 20 x 11/16”
self drilling screws.
Fasten center of the u-bar as shown
to the rib using (2) 1/4”- 14 x 5/8” self
tapping screws one 6” to the left and one
6” to the right of the center of the door
section.
NOTE: after completing this step,
continue with step 11.
U-bar
(2) 1/4”-20 x 11/16”
sElF DRIllING sCREWs
Power Drill
7/16” socket
Driver
(2) saw horses
9
u-BaR
OPERaTOR BRaCkET
(INsTallED IN ThE sTEP 11)
TOP DOOR sECTION
6”
6”
ATTAChINg CENTER Of U-bAR ATTAChINg ENDS Of U-bAR
(2) 1/4”-14 x 5/8”
sElF TaPPING
sCREWs