Wagner SprayTech Twin Stroke Piston Pump 9146 - Manual (Page 14)

14 English
5. Unclip the return tube from the suction tube and place it
into the waste container. Turn the PRIME/SPRAY knob to
PRIME.
8. While pulling the trigger, turn the PRIME/SPRAY knob to
SPRAY to purge material from the hose back into the
original container.
7. Place the original material container next to the waste
container. Aim the spray gun into the side of the original
material container and hold the trigger.
Move on to Cleaning the Spray Gun Components
S
P
R
A
Y P
R
IM
E
Waste
container
Containers should
be touching
Original
material
container
Hold trigger
9. When cleaning solution flows from the spray gun, keep
holding the trigger and aim the spray gun into the side of
the waste container.
10. Trigger the gun until the fluid flowing out of the gun is
clear. You may need to empty the waste container and
continue flushing.
11. Turn the PRIME/SPRAY knob to PRIME and trigger gun
to relieve pressure.
Hold
trigg
er
Spray material
into original container
Spray water into
waste container
6. Turn water supply on. Turn pump ON (l). Water will go
into the suction tube and out through the return tube. Let
pump run for a few minutes to allow the return tube to be
flushed.
Leave pump running
through steps 7 and 8.
Keep holding trigger through next steps.
SPRAY
PRIME
Cleanup -
Latex materials (continued)