Watlow MINICHEF Convection Oven Application - Manual (Page 32)

3 0 ■ Wa t l o w M I N I C H E F 2 0 0 0 A p p l i c a t i o n 9
4. When the cooking sequence is finished, [``end] will appear on the display and an
audible tone will sound for two seconds. The controller will then go into idle.
5. Once the controller goes into idle, the Start/Stop indicator light will switch off.
6. To repeat cooking, repeat steps 1 through 4.
View Actual Oven Temperature
While cooking you can view the actual oven temperature by pressing and holding the
Cook Temp key for three seconds.
Adjust a Menu While Cooking
You can adjust the temperature and time settings during the cooking sequence by per-
forming the actions shown under “Set the menu” earlier in this section.
Changes can be made to temperature and time only during the portion of the cooking
sequence in which they are active. For example: a change to the first cooking tempera-
ture [tENP1] can be made only when the first cooking temperature is being run during
the cooking sequence.
Temperature changes made while cooking are saved and become part of the permanent
menu. Time changes are not saved and do not become part of the permanent menu.
Pause a Menu
While cooking, you can pause cooking time by pressing the Start/Stop key once. The
Start/Stop key indicator light will flash rapidly. [PAUSE] will appear on the display. To
resume, press the Start/Stop key again.
Cancel a Menu
Canceling a menu stops the controller completely. The controller does not maintain set
point temperatures or run time. You cancel a menu to change the menu, stop menu
operation for any reason, or are preparing to shut off the oven.
• Press the Start/Stop key for 2 seconds. Heat outputs will switch off. Heat output
indidicator lights will switch off. [`idLE] or time of day will be on the display.
Change Menu or Restart
With the controller in idle:
1. Set a menu as shown earlier.
2. Press the Start/Stop key.
Door Opening
When you open the oven door (when the oven door is open, the switch is closed and
Event Input 1 is turned on) the unit will act as described below.
During the cooking sequence: time is paused - [`door] will appear on the display.
The heat and fan output signals will shut off.
During the preheat sequence: [`door] will appear on the display. The heat and fan
output signals will be shut off.
During idle, the fan output signals will be shut off.
When you close the door the unit will operate normally.