Run a menu (when preheat feature is not active) – Watlow MINICHEF Convection Oven Application User Manual

Page 20

1 8

■

Wa t l o w M

I N I

H E F

2 0 0 0

A p p l i c a t i o n 8

With Sound set to 0, the controller automatically switches to idle in which the con-
troller does not maintain temperature and does not run time. [`idle] or current
time will appear on the display. The Start/Stop key indicator light will be off.

With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible
tone will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge the tone by pressing the Start/Stop key or it will time out in 1 to 20
seconds and go into idle. The Start/Stop key indicator light will be off.

With Sound set to 4 or 5, [``end] will appear on the display and the Start/Stop
key indicator light will flash rapidly. You must acknowledge the audible signal by
pressing the Start/Stop key. Once acknowledged the audible signal is silenced and
the controller goes into idle. The Start/Stop key indicator light will be off.

Once the controller goes into idle, the Start/Stop key indicator light and the heat
outputs will switch off. The controller will not regulate to any temperature.

To repeat cooking, repeat steps 1 through 3 or 4.

Run a Menu (when preheat feature is not active)

This procedure describes how to run an active menu when the preheat feature is inac-
tive - in other words, when the [ready] parameter in the [setUp] function of the
Configuration mode is set to [```no].

Select a menu as shown earlier.

With [`idle], time of day or a menu number on the display, place the food in the
oven.

Press the Start/Stop key.

The Start/Stop key indicator will light up. Time will count down on the display.

The unit will run the following four-step cooking sequence:

Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2
plus Time 3 plus Time 4.

Set point 1 and Fan 1 will run until Time 1 expires.

Set point 2 and Fan 2 will run until Time 2 expires. You will not see the switch-over
from Time 1 to Time 2.

Set point 3 and Fan 3 will run until Time 3 expires. You will not see the switch-over
from Time 2 to Time 3.

Set point 4 and Fan 4 will run until Time 4 expires. You will not see the switch-over
from Time 3 to Time 4.

When the cooking sequence is finished, one of the following will happen, depending
on the way the controller was programmed at [Etype] / [sound]: