Watlow MINICHEF Convection Oven Application - Manual (Page 26)

2 4 ■ Wa t l o w M I N I C H E F 2 0 0 0 A p p l i c a t i o n 9
Auto-tuning Note:
Before auto-tuning Application 9, [teNp1] in the operations menu must first be set to a
value that is typical of your application. (See Hardware & Software Setup Guide for
information.) Then set [tHerl] / [tunE1] to [```on]. After you accept [```on], by
pressing “Enter,” the controller will display [`tunE] while auto-tuning is taking place.
The controller will cancel the auto-tuning process if it cannot be completed in 80 min-
utes. You can cancel the auto-tuning process at any time by pressing either key C or key
D and accepting [``Off], by pressing “Enter,” when it appears.