Viking SLAL - Manual (Page 30)

fIGURE 125
fIGURE 126
fIGURE 122
8.06
8.10
fIGURE 123
8.03
8.04
fIGURE 124
8.02
8.01
2.01
SECTION TSM 288 ISSUE A PAGE 30 OF 36
5.6 ROTaRY sEal REMOVal
• To remove the seal face in the rotor use the seal face
removal tool
• The tool locates on the rubber L-cup and when pressed in
the seal face will extrude up into the tool allowing ease of the
seal face removal (A press tool may be required)
• Install the O-ring (8.06) into the seal housing and then install
the seal housing (8.10) into the casing
• making sure that the location recesses line up with the seal
washers (8.08) (See Figure 47 and Figure 44)
• Install the O-ring (8.04) onto the static seal (8.03) and then
install the static seal into the casing – make sure that the
location slots line up with the pins in the seal housing
• Install the L-cup (8.01) and the rotary face (8.02) into the
rotor (2.01)
The seals are now assembled.
For rotor and head installation see pump assembly section.