Viking SLAL - Manual (Page 13)

5.03 4.01 5.04
fIGURE 19
4.01
fIGURE 20
4.01 5.04
fIGURE 21
TWO TIMING
MaRKs ON dRIVE
ONE TIMING
MaRK ON laY
fIGURE 22i
fIGURE 18
5.01 / 5.02 5.12
5.03
fIGURE 22ii
NOTE: On a right hand helical gear, the form of
the teeth slants to the right.
SECTION TSM 288 ISSUE A PAGE 13 OF 36
4.1 PUMP assEMblY sla-slf
4.1.1 sHafT assEMblY
• Install a nominal 0.1 mm (0.003”) shims (5.12) and bearing
cone (5.03) onto shaft (5.01 / 5.02)
• Install shafts assemblies into the bearing housing (4.01)
• Install rear bearing cone (5.04) into the bearing housing
(4.01)
• Install bearing cups (5.03 / 5.04) into the bearing housing
(4.01)
• To set the timing marks on the gears (5.06) place the gears
next to each other and line up the keyways, you can now
punch three timing marks to show the correct alignment of
the gears see Figure 22i.
NOTE: When installing the gears onto the shaft make sure
that you use the right hand helical gear on the drive shaft (See
Figure 22ii) The right hand helical gear will have the letter ‘D’
stamped on the face.