Viking SLAL - Manual (Page 23)

fIGURE 74
fIGURE 76
8.01
fIGURE 73
8.02
8.04
8.06
8.07
8.05 8.03
8.09
8.08
fIGURE 75
8.08
8.09
fIGURE 72ii
fIllING POINT
fIGURE 72i
1.01
1.03
fIGURE 71
1.01
1.02
SECTION TSM 288 ISSUE A PAGE 23 OF 36
5.0 sEals
5.1 sINGlE sEal sla – slG
• Install the seal washers (8.08) and the seal screws (8.09)
The washers overlap the seal bore – this locates and provides
drive to the seal.
• Install the head O-ring (1.02) into the head (1.01)
• Install the head (1.01) and secure with the dome nuts
(1.03). (See section 6.2 for torque settings)
• Rotate pump so filler hole is uppermost, add lubricant. (See
section 6.4 for lubricants and quantities)