Viking SLAL - Manual (Page 26)

fIGURE 101
3.01 4.07
fIGURE 100
3.01
7.03
fIGURE 99
5.15
fIGURE 98
fIGURE 94
8.01
8.02 2.01
fIGURE 96
fIGURE 95
8.01
8.02
8.04
8.06
8.08
8.17
8.09
8.18
8.16 8.05 8.03
fIGURE 97
8.08
8.09
SECTION TSM 288 ISSUE A PAGE 26 OF 36
NOTE: the slinger has raised sections on the internal diameter,
which press onto the shaft
• Install the guard (7.03) onto the rear of the casing (3.01)
• Install the casing (3.01) and secure with screws (4.07) (See
section 6.2 for torque settings)
The washers overlap the seal bore – this locates and provides
drive to the seal.
• Install the slinger (5.15)
• Install the l-cup (8.01) and the rotary face (8.02) into the rotor
(2.01)
The seals are now assembled.
For rotor and head installation see pump assembly section
5.3 sINGlE flUsH slG
• Install the seal washers (8.08) and the seal screws (8.09)