Adjusting the yaw, Pre l iminar y – Vidikron 85 User Manual

Page 52

Vidikron Vision 85 Owner’s Operating Manual

PRE

IMINAR

The anamorphic lens will almost always be angled with respect to the projector; this is
normal. Once the proper lens angle has been set, firmly tighten the Pitch Adjustment Screws
to secure the lens in place.

Adjusting the Yaw: Loosen the Yaw/Z-Adjustment Knobs to allow the lens to pivot freely
from side to side. Then, angle the lens to even out any left-right pincushion distortion:

Once the proper lens angle has been set, firmly tighten the Yaw/Z-Adjustment Knobs to
secure the lens in place.

There may be some pincushion distortion even after the lens is properly
adjusted, especially at shorter throw distances. If this is the case, Vidikron
recommends that you slightly over-scan the image into the screen frame
area to mask the distortion.

Correct Lens Angle

Incorrect Lens Angle

Note

Wrong Position

Correct Position

Anamorphic Lens (Top View)