Vidikron 85 - Manual (Page 48)

Installation
36 Vidikron Vision 85 Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting to AC Power The Vision 85 system includes two (2) AC power cords (one each for the VHD Controller and
projector).
VHD Controller: Plug the female end of one power cord into the AC receptacle on the rear of
the VHD Controller. Connect the other end to your AC power source (100 to 240 VAC).
Projector: Similarly connect the Vision 85 to a nearby 100 to 240 VAC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, a third power cord is
provided for the lens motor. Plug the female end of the AC power cord into the AC receptacle
on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.
3.7
Turning on the Power 1. Turn on your source components.
2. Turn on the main power switch at the rear of the VHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear of
the AutoScope lens motor. The lens motor power switch is located next to the AC input
(see Figure 3-16).
4. Press the ON button on the remote control – or the POWER ( ) button on the VHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
VHD Controller front panel briefly displays “Starting Display.”
5. When the projector is ready for use, the fluorescent display indicates the active source,
signal format (NTSC or PAL), input resolution and aspect ratio; for example:
➤
The input voltage to the AutoScope lens motor must be between 100 and
120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC
power source!
Caution
Component SD NTSC 480i
16:9 V85
Current Source Format
Input
Resolution
Aspect Ratio