Vidikron 85 - Manual (Page 49)

Installation
Vidikron Vision 85 Owner’s Operating Manual 37
PRE
L
IMINAR
Y
3.8
Adjusting the Picture
Orientation By default, the Vision 85 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or mounted
on a ceiling, you must change the picture orientation. To do this:
1. Select an input OTHER THAN HDMI 1 or HDMI 2 on the VHD Controller.
2. Press MENU and enter the Service Menu passcode.
3. Select Service from the Main Menu.
4. Select Display Device from the Service Menu, then select Configure.
5. Press , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation
method.
3.9
Primary Lens Adjustments
Focus and Zoom To focus the projected image, gently rotate the lens
by hand.
To enlarge the picture (zoom in), move the zoom tab
toward the Vidikron logo on the front of the projector.
To make the picture smaller (zoom out), move the tab
in the other direction.
Vertical Lens Shift To change the projected image position, use a 9/64” hex driver to shift the lens in the desired
direction; see Figure 3-19. The vertical lens shift control is at the top of the projector. (The
tool will automatically center on top of the adjustment nut when inserted into the access
hole.)
Figure 3-19. Vertical Lens Shift Adjustments
You must enter a passcode to access the Service menu.
Note
Zoom
in
Focus
Zoom
out
9/64” Hex Wrench