Vantec UGT-IS100R - Manual (Page 6)

UGT-IS100R
Page 6
CON3
1-2 close Enable SATA Port
CON2
J5-J8
2-3 close Enable SATA Port
CON4
Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCI-E slot.
4. To install the bard, carefully align the card’s bus connector
with the selected PCI-E slot on the motherboard. Push the
board down firmly.
5. Attach your internal or external devices to the 4+1 SATA II
300 IDE/PATA PCI-E Combo Host Card w/ RAID & Port
Multiplier .
6. Replace the slot bracket’s holding screw to secure the card.
7. Replace the computer cover and reconnect the power cord.