Vantec UGT-IS100R - Manual (Page 15)

UGT-IS100R
Page 15
directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. At the Windows Setup screen, press
F6 to install the driver.
4. When prompted, press
S to specify the location of the driver.
5. Insert the floppy disk, then press
Enter.
6. Select
(Windows XP/2003 x64) RAID/AHCI Driver for
JMicron JMB36X Controller, then press Enter.
7. Press
Enter to finish driver installation, then follow the
on-screen instructions to complete the Windows installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. Please insert the CD driver bound with 4+1 SATA II 300
IDE/PATA PCI-E Combo Host Card w/ RAID & Port Multiplier
into your CD-ROM Drive.
3. At the Windows desktop, click
Start, then Run.
4. Type
D:\
UGT-IS100R\XP_2003_Vista\setup.exe , click
OK.
(Change
D:\ to match your CD-ROM drive letter)
5. Follow the on-screen instructions to complete the