Vantec UGT-IS100R - Manual (Page 18)

UGT-IS100R
Page 18
F
3. At the Windows Setup screen, press
Load Driver to install
the RAID driver.
4. Insert the floppy disk, please select
JMicron JMB36X
Controller (A:\jRAID_f.inf), then press Next. (Change A:\
to match your floppy drive letter)
5. Follow the on-screen instructions to complete the Windows
installation.
or An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up
to Windows.
2. Please insert the CD driver bound with 4+1 SATA II 300
IDE/PATA PCI-E Combo Host Card w/ RAID & Port Multiplier
into your CD-ROM Drive.
3. At the Windows desktop, click
Start, then Run.
4. Type
D:\
UGT-IS100R\XP_2003_Vista\setup.exe , click
OK.
(Change
D:\ to match your CD-ROM drive letter)
5. Follow the on-screen instructions to complete the
installation.
6. Restart Windows to complete the installation.