Vantec UGT-IS100R - Manual (Page 16)

UGT-IS100R
Page 16
F
installation.
6. Restart Windows to complete the installation.
For Windows® Vista
or A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the “ UGT-IS100R\2000_XP_2003_Vista\Floppy32 ” folder,
found on the driver CD, onto a blank floppy disk then follow
the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. At the Windows Setup screen, press
Load Driver to install
the driver.
4. Insert the floppy disk, please select
JMicron JMB36X
Controller (A:\jRAID_f.inf), then press Next. (Change A:\
to match your floppy drive letter)
5. Follow the on-screen instructions to complete the Windows
installation.
For An Existing Installation