beautypg.com

M-AUDIO Delta RBUS User Manual

Page 48

background image

5. Open the Delta Control Panel by double clicking the icon in your

Windows Control Panel (or, on the Mac, wherever you’ve placed your
control panel), and then click on the ‘Hardware Settings’ tab.

6. Select ‘Internal Xtal’ as the master clock source. This allows the Delta

R-BUS to derive its sample rates from its internal clock oscillator.
‘Internal Xtal’ is the default setting for the Delta Control Panel, so
selecting it may not be necessary (it may already be selected).

7. Under "CODEC Sample Rate," verify that the "Rate Locked" checkbox

is not activated. This will allow your application software to set the
Delta R-BUS sample rate as it pleases.

8. Since this example will include the use of the monitor mixer, we will

activate the "Reset Rate When Idle" feature. This will make sure the
monitor mixer is running at a decent sample rate while the system is
idle – this prevents the mixer sample rate from being set too low and
therefore lowering its frequency response. Select a sample rate in the
"CODEC Sample Rate" group to use as this idle sample rate. Choose
a 44.1kHz or higher setting for best results, and select the same sample
rate you will be using in your application if possible. We’ve chosen
44,100kHz for this example, which is a standard operating sample rate
for digital multitracks should you decide to transfer this audio to a
Roland device. A general rule of thumb is to multiply the highest
frequency you would like to capture by two and add maybe a little on
top of that – that gives you a suitable sample rate. Also keep in mind
that if the final results of your work will end up on a CD-ROM burned
from your WAV file or AIFF, you probably want to use 44.1kHz, the
native sample rate of "redbook" CD audio.

48