VXI VM4016 - Manual (Page 24)

VXI Technology, Inc.
24 VM4016 Programming
INHOUSE:REG_ENABLE
The INHOUSE:REG_ENABLE command controls the masking for REGINT. REG_ENABLE 0
means that backplane interrupts cannot be generated. If the REG_ENABLE is 1, then backplane
interrupts can be generated. If PSEUDO is set, then a write to the register at offset 0x38 also
controls the masking. Enable or disable capabilities are provided in the pseudo register interface to
allow a complete register interface. It is important to note that all letters of the command must be
provided as there is no short form for this command.
INHOUSE:REG_ENABLE Where is 0 | OFF | 1 | ON.
EXAMPLES
INHOUSE:REG_ENABLE 1
Enables the REGINT type interrupt
generation
INHOUSE:REG_ENABLE?
Returns 1 to state that backplane
1 interrupting is currently enabled.
INHOUSE:REG_ENABLE 0 Disabling REGINT interrupt generation.
INHOUSE:REG_ENABLE?
Returns 0 to state that backplane
0 interrupting is currently disabled.