Set the clock, Answering system – VTech CS6129-54 User Manual
Page 42

www.vtechphones.com
38
Answering system
Set the clock
Pror to playng a message, the answerng system announces when t was
receved. Before usng the answerng system, set the year, tme and day, so that
messages are dated correctly. If the clock s not set before new messages are
recorded, the system wll announce
“Time and day not set,” before each message
s played to remnd you to set the clock.
Press
CLOCK. The system announces the clock settng (e.g. year, tme and
day), then announces:
“To set the clock, press
CLOCK.”
Press
CLOCK. The system announces the current year.
Press
/SKIP or /REPEAT untl the system announces the correct year, then
press
CLOCK. The system announces the current hour.
Press
/SKIP or /REPEAT untl the system announces the correct hour, then
press
CLOCK. The system announces the current mnute.
Press
/SKIP or /REPEAT untl the system announces the correct mnute,
then press
CLOCK. The system announces the current day.
Press
/SKIP or /REPEAT untl the system announces the correct day, then
press
CLOCK. After a confirmation tone, the system announces the new clock
settng and exts programmng mode.
1.
2.
3.
4.
5.
6.
If you have caller
ID servce, the
clock wll be set
automatcally wth
ncomng calls,
but you wll need
to make sure the
year s correct.
See
Set the clock
for nstructons
on how to set the
year, tme and day
manually.
Press and hold
/
SKIP or
/
REPEAT whle
settng the mnutes
or year to advance
or decrease by
ncrements of 10.
•
•