VXI VT1422A - Manual (Page 322)

320 VT1422A Command Reference Chapter 7
OUTPut
OUTPut:TTLTrg[:STATe]
OUTPut:TTLTrg:STATe <ttltrg_cntrl> specifies which VXIbus TTLTRG line
is enabled to source a trigger signal when the module is triggered. TTLTrg can
specify line 0 through 7. For example, …:TTLTRG4 or TTLT4 for VXIbus TTLTRG
line 4.
Parameters
Comments •
Only one VXIbus TTLTRG line can be enabled simultaneously.
•
When Accepted: Not while INITiated
•
Related Commands: ABORT, INIT…, TRIG…
•
*RST Condition: OUTPut:TTLTrg<0 through 7> OFF
•
Send with VXIplug&play Function: hpe1422_cmd(...)
Usage OUTP:TTLT2 ON
Enable TTLTRG2 line to source a trigger
OUTPUT:TTLTRG7:STATE ON
Enable TTLTRG7 line to source a trigger
OUTPut:TTLTrg[:STATe]?
OUTPut:TTLTrg[:STATe]? returns the current state for TTLTRG line .
Comments •
Returned Value: Returns 1 or 0. The data type is int16.
•
Related Commands: OUTP:TTLT
•
Send with VXIplug&play Function: hpe1422_cmdInt16_Q(...)
Usage OUTP:TTLT2?
See if TTLTRG2 line is enabled
(returns 1 or 0)
OUTPUT:TTLTRG7:STATE?
See if TTLTRG7 line is enabled
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
ttltrg_cntrl boolean (uint16) 1 | 0 | ON | OFF none