VXI VT1422A - Manual (Page 384)

382 VT1422A Command Reference Chapter 7
STATus
•
Returned Value: Decimal weighted sum of all set bits. The data type is uint16.
•
Related Commands: *CAL?, CAL:ZERO, INITiate[:IMMediate],
STAT:OPER:EVENT?, STAT:OPER:ENABLE, STAT:OPER:ENABLE?
•
*RST Condition: No Change
•
Use VXIplug&play function: hpe1422_operCond_Q(...)
Usage STATUS:OPERATION:CONDITION?
Enter statement will return value from
condition register
STATus:OPERation:ENABle
STATus:OPERation:ENABle <enable_mask> sets bits in the Enable register
that will enable corresponding bits from the Event register to set the Operation
summary bit.
Parameters
Comments •
The parameter may be sent as decimal, hex (#H), octal (#Q),
or binary (#B).
•
VXI Interrupts: When Operation Status Group bits 4, 8, 9, 10, or 11 are enabled,
VXI card interrupts will occur as follows:
When the event corresponding to bit 4 occurs and then is cleared, the card
will generate a VXI interrupt. When the event corresponding to bit 8, 9, 10,
or 11 occurs, the card will generate a VXI interrupt.
NOTE: In C-SCPI, the C-SCPI overlap mode must be on for VXIbus
interrupts to occur.
•
Related Commands: *STB?, SPOLL, STAT:OPER:COND?,
STAT:OPER:EVENT?, STAT:OPER:ENABLE?
•
Cleared By: STAT:PRESet and power-on.
•
*RST Condition: No change
•
Send with VXIplug&play Function: hpe1422_cmd(...)
Usage STAT:OPER:ENABLE 1
Set bit 0 in the Operation Enable register
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
enable_mask numeric (uint16) 0 - 32767 none