VXI VT1422A User Manual
Page 457
Error Messages 455
3033
'0x2: DSP-Parameter out of range.'
3034
'0x4: DSP-Flash rom erase failure.'
3035
'0x8: DSP-Programming voltage not present.'
3036
'0x10: DSP-Invalid SCP gain value.' Check that SCP is
seated or replace SCP. Channel numbers are in FIFO.
3037
'0x20: DSP-Invalid *CAL? constant or checksum.
*CAL? required.'
3038
'0x40: DSP-Couldn't cal some channels.' Check that
SCP is seated or replace SCP. Channel numbers are
in FIFO.
3039
'0x80: DSP-Re-Zero of ADC failed.'
3040
'0x100: DSP-Invalid tare CAL constant or checksum.'
Perform CAL:TARE - CAL:TARE? procedure.
3041
'0x200: DSP-Invalid Factory CAL constant or
checksum.' Perform A/D Cal procedure.
3042
'0x400: DSP-DAC adjustment went to limit.'
Execute *TST?
3043
'0x800: DSP Status--Do *CAL?.'
3044
'0x1000: DSP-Overvoltage on input.'
3045
'0x2000: DSP-cal constant out of range.'
Execute *CAL?
3046
'0x4000: DSP-ADC hardware failure.'
3047
'0x8000: DSP-reserved error condition.'
3048
'Calibration or Test in Process.'
3049
'Calibration not in Process.'
3050
'ZERO must be sent before FSCale.' Perform A/D Cal
sequence as shown in Command Reference under
CAL:CONF:VOLT.
3051
'Memory size must be multiple of 4.' From
MEM:VME:SIZE. Each VT1422A reading requires
4 bytes.