VXI VT1422A - Manual (Page 299)

VT1422A Command Reference 297 Chapter 7
INPut
INPut
The INPut subsystem controls configuration of programmable input Signal
Conditioning Plug-Ons (SCPs).
Subsystem Syntax INPut
:FILTer
[:LPASs]
:FREQuency <cutoff_freq>,(@<ch_list>)
:FREQuency? (@<channel>)
[:STATe] 1 | 0 | ON | OFF,(@<channel>)
[:STATe]? (@<channel>)
:GAIN <chan_gain>,(@<ch_list>)
:GAIN? (@<channel>)
:LOW <wvolt_type>,(@<ch_list>)
:LOW? (@<channel>)
:POLarity NORMal | INVerted,(@<ch_list>)
:POLarity? (@<channel>)
INPut:FILTer[:LPASs]:FREQuency
INPut:FILTer[:LPASs]:FREQuency <cutoff_freq>,(@<ch_list>) sets the cutoff
frequency of the filter on the specified channels.
Parameters
Comments •
The parameter may be specified in kilohertz (kHz). A
programmable Filter in either an SCP or a Remote Signal Conditioning unit
(RSC) has a choice of several discrete cutoff frequencies. The cutoff frequency
set will be the one closest to the value specified by .
•
For the VT1529A/B, this command affects an 8-channel bank, not a single
channel.
•
Sending MAX for the selects the SCP or RSC's highest cutoff
frequency. Sending MIN for the selects the SCP or RSC's lowest
cutoff frequency. To disable filtering (the "pass through" mode), execute the
INP:FILT:STATE OFF command.
•
Sending a value greater than the SCP's highest cutoff frequency or less than the
SCP's lowest cutoff frequency generates a -222 "Data out of range" error.
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
cutoff_freq numeric (float32)
(string)
see comment |
MIN | MAX
Hz
ch_list channel list (string) 100 - 15731 none