Uniden DECT2188 Series - Manual (Page 5)

Test the Connection
Pick up the corded handset from the base. You should hear a dial
tone and the display on the base should say Talk. When you get a
dial tone, make a quick test call.
If... Try...
the display says Check Tel Line
or you don't hear a dial tone
checking the connection between
the base and the phone jack.
you keep hearing a dial tone
changing to pulse dialing (see page
4).
there's a lot of noise or static
see page 27 for tips on avoiding
interference.
Set Up the Accessory Handset(s)
If your phone came packaged with accessory handsets, follow the
steps below to get your cordless handsets ready for use.
Install the battery
Unpack all handsets, battery packs,
and battery covers. If any handset
has the battery cover already
attached, press in on the notch and
slide the cover down and off.
Line up the red and black wires
on the battery pack with the
label inside the handset.
Push the battery pack
connector in until it clicks into
place. Tug gently on the wires
to make sure the battery pack
is securely connected.
Place the cover over the battery
compartment and slide it up into
place.
1.
2.
3.
4.
Red
Black
Red
Black