Uniden DECT2188 Series - Manual (Page 31)

If... Try...
you don't hear a dial tone
the display says Registration Failed
-
-
Making sure the handset is fully
charged, then start over at step 1.
To register a handset to a different base, see the section
"expanding Your phone" in the user's guide for the other base.
Handling Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the
exterior plastic housing is affected, wipe off the liquid, and use as
normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can
be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow these steps:
Handset Base
Remove the battery cover &
disconnect the battery.
Let dry for at least 3 days with the
battery disconnected and the cover
off for ventilation.
After the handset dries, reconnect
the battery pack and replace the
cover. Recharge the battery fully
(15-20 hours) before using.
1.
2.
3.
Disconnect the AC adapter to cut
off the power.
Disconnect the telephone cord.
Let dry for at least 3 days before
reconnecting.
1.
2.
3.
IMporTaNT: You must unplug the telephone line while
recharging the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up
the drying process. This will cause permanent damage
to the handset, base and the microwave oven.

