beautypg.com

Toshiba P200 Series User Manual

Page 70

background image

User’s Manual

4-13

Operating Basics

5. Press gently at the centre of the disc until you feel it click into place. The

disc should lie below the top of the spindle, flush with its base.

6. Push the centre of the drawer to close it. Press gently until it locks in

place.

Closing the drive drawer

Removing optical disc media

To remove the disc, follow the steps below.

1. To pop the drawer partially open, press the eject button. Gently pull the

drawer out until it is fully opened.

2. The disc extends slightly over the sides of the drawer so you can grasp

it. Hold it gently and lift it out.

Be careful not to touch the lens or the area around it. Doing so could cause

the drive to malfunction.

If the disc is not seated properly when the drawer is closed, it might be

damaged. Also, the drawer might not open fully when you press the eject

button.

Do not press the eject button while the computer is accessing the disc

drive. Wait for the optical disc indicator to go out before you open the

drawer. Also, if the disc is spinning when you open it, wait for it to stop

before you remove it.

When the drawer pops open slightly, wait a moment to make sure the

disc has stopped spinning before pulling the drawer fully open.

Turn off the power before you use the eject hole. If the disc is spinning

when you open the drawer, it could fly off the spindle and cause injury.