Lan -7 – Toshiba P200 Series User Manual
Page 64
User’s Manual
4-7
Operating Basics
Connecting the internal modem
Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.
LAN
The computer is equipped with networking hardware that supports Ethernet
LAN (10 megabits per second, 10BASE-T) or Fast Ethernet LAN
(100 megabits per second, 100BASE-T).
Connecting the LAN cable
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you
can connect using either a CAT5 or a CAT3 cable.
If you are using 100BASE-TX Fast Ethernet you must connect using a
CAT5 cable.
Do not pull on the cable or move the computer while the cable is
connected.
If you find that the modem speed is low or communication is interrupted
when you are using the modem, please set the CPU speed to Maximum
within the TOSHIBA Power Saver utility.
Do not install or remove an optional memory module while the Wake-up on
LAN feature is enabled.
The Wake-up on LAN feature does not work on battery power. In
Hibernate/Power off mode you should always leave the computer
connected to the AC adapter if you are using this feature.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.