Toshiba PSA20 - Manual (Page 143)

8-7
O
PTIONAL
D
EVICES
Installing memory module
Follow the steps below to install a memory module.
1. Set the computer to boot mode and turn the computer’s power off. Make sure
the
Power indicator is off.
2. Remove universal AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
Replacing the battery pack section in Chapter 6, Power, for details.
4. Turn the computer right side up and open the display panel. Tilt the display
panel slightly beyond the upright position before removing the keyboard
display.
5. Slip your fingernails under two notches on the keyboard brace and pull off the
keyboard brace in the direction indicated by the arrows.
Figure 8-5 Removing the keyboard brace
Memory expansion
K
EYBORD BRACE
N
OTCHES