Toshiba RAS-13UAV-E2 - Manual (Page 34)

FILE NO. SVM-03008
– 33 –
8-4-3. Power failure during timer operation
When the unit is in timer operation, if it is turned off
because of power failure, the timer operation is
cancelled. Therefore, set the timer operation again.
NOTE:
The Every Timer is reset while a command signal can
be received from the remote controller even if it
stopped due to a power failure.
8-5. Filter Check Lamp
When the elapsed time reaches 1000 hours, the filter
check lamp indicates. After cleaning the filters, turn off
the filter check lamp.
8-4-2. How to cancel auto restart function
To cancel auto restart function, proceed as follows:
Repeat the setting procedure: the unit receives the
signal and beeps three times.
The unit will be required to be turned on with the
remote control after the main power supply is turned
off.
•
When the system is on standby (Not operating)
•
When the system is operating
•
While this function is being set, if the unit is in operation, the orange lamp is on.
Operation Motions
Push [TEMPORARY] button for more The unit is on standby.
than three seconds.
The unit starts to operate. The orange lamp is on.
After approx. three seconds,
The unit beeps three times The lamp changes from
and continues to operate. orange to orange.
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it off.
→
→
TEMPORARY button
0
3S
Operation Motions
Push [TEMPORARY] button for more The unit is in operation. The orange lamp is on.
than three seconds.
The unit stops operating. The orange lamp is turned off.
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it on.
→
→
TEMPORARY button
0
3S
8-5-1. How to turn off filter check lamp
Push [FILTER] button on the remote control.
Or push [TEMPORARY] button on the indoor unit.
Then we have to clarify it.
NOTE :
If [TEMPORARY] button is pushed while the filter
check lamp is not indicating, the indoor unit will start
the automatic operation.
When you want a temporary operation while the filter
lamp lights, put out the lamp once, and then push the
TEMPORARY button.