Toshiba RAS-13UAV-E2 - Manual (Page 33)

FILE NO. SVM-03008
– 32 –
8-4-1. How to set auto restart function
To set the auto restart function, proceed as follows:
The power supply to the unit must be on; the function
will not set if the power is off.
Push the [TEMPORARY] button located in the center
of the front panel continuously for three seconds.
The unit receives the signal and beeps three times.
The unit then restarts operating automatically in the
event of power supply being accidentally shut down.
8-4. Auto Restart Function
The indoor unit is equipped with an automatic
restarting function which allows the unit to restart
operating with the set operating conditions in the event
of power supply being accidentally shut down. The
operation will resume without warning three minutes
after power is restored. This function is not set to work
when shipped from the factory. Therefore it is
necessary to set it to work.
•
When the unit is on standby (Not operating)
•
When the unit is in operation
•
While this function is being set, if the unit is in
operation, the orange lamp is on.
•
This function can not be set if the timer operation
has been selected.
•
When the unit is turned on by this function, the
louver will not swing even though it was swinging
automatically before shutting down.
Operation Motions
Push [TEMPORARY] button for more The unit is on standby.
than three seconds.
The unit starts to operate. The green lamp is on.
After approx. three seconds,
The unit beeps three times The lamp changes from
and continues to operate. green to orange.
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it off.
→
→
TEMPORARY button
0
3S
Operation Motions
Push [TEMPORARY] button for more The unit is in operation. The green lamp is on.
than three seconds.
The unit stops operating. The green lamp is turned off.
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it on.
→
→
TEMPORARY button
0
3S
•
While the filter check lamp is on, the
TEMPORARY button has the function of filter
reset button.